Endress+Hauser Topclean S CPC30, Руководство по эксплуатации

Страница: 107 / 178

Topclean S 6 Commissioning
Hauser 107
Factory reset:
Abort
Only start up data
Only calibration data
Complete reset
CPC data
Service data
Operation log
Error log
Calibration log
Set default
Here you can select the data which you wish to reset to the
factory settings.
!
Note!
Danger of data loss. Selecting a point and confirming with
"Enter" deletes all the settings you made in this area!
Selecting "
Abort" leaves this field without changing the
values.
Calibration data : All saved data for calibrations such as
zero point, slope, and offset
Start up data : The remaining data to be set
Complete reset : Calibration data + setting data
CPC data : Topclean configuration data, e.g. configuration
of cleaning and calibration programmes
Service data : All data + lo reset counters
Service data / logs:
These functions are for authorised service personnel only.
The service code is required.
Service data / logs:
0000 Service code entry required
!
Note!
For service access code, contact the Hauser
service.
Incorrect service code entered. Note in display:
Incorrect service code entry (back to the previous field)
Simulations:
Simulation:
Output 1:
Output 2: off
12.00 mA
04.00 mA
Adapt simulation (current outputs)
Simulation off : The frozen values from the last
measurement are used for the simulation.
Simulation on : The current values for the outputs can be
changed (Output 1, Output 2)
Simulation:
pH/mV:
Temperature: off
pH 07.00
025.00°C
Adapt simulation (measured value/temperature)
Simulation off : The frozen values from the last
measurement are used for the simulation.
Simulation on : The values (measured value/temperature)
can be changed.
Simulation:
Alarm relay:
Relay 1:
Relay 2:
... off
off
off
off
Adapt simulation (contacts)
Simulation off : The last statuses are frozen and used for
the simulation.
Simulation on : The contacts can either be opened (on) or
closed (off).
!
Note!
If you return to measurement mode with the simulation
switched on, "Simul" and "Hold" flash in the display.
CHOICE
(default = bold) INFO
Hold
pH 7. 00
Diag
[E] Edit[¯]
Next
Set default
Abort
Only start up data
Only calibration data
Complete reset
CPC data
¯
Hold
pH 7. 00
Diag
[E] Edit[ ¯®]
Next
Service code
00000
0...99999
Hold
pH 7. 00
Diag
[E] Next
Simulation
Simulation:
Output 1: 12. 00mA
Output 2: 08.00mA
off
Select[®]