Endress+Hauser Topclean S CPC30, Руководство по эксплуатации

Страница: 5 / 178

Topclean S 1 Safety instructions
Hauser 5
1 Safety instructions
1.1 Designated use
Topclean S CPC30 is a fully automatic measuring and cleaning system for pH and redox
measurements.
The system is supplied complete with power supply cables and bottle hose.
The Ex version of the Topclean S CPC30 allows operation even in explosive atmospheres.
The manufacturer is not liable for damage caused by improper or non-designated use.
1.2 Installation, commissioning, operation
Note the following points:
• If the system is used improperly or other than for its designated use, it may pose a hazard, e.g.
due to improper connection.
• Installation, electrical connection, commissioning, operation and maintenance of the measuring
system must therefore be carried out exclusively by trained specialists authorised by the system
operator.
• Technical personnel must have read and understood these operating instructions and must adhere
to them.
• Always follow the regulations in your country pertaining to the opening and repairing of electrical
instruments.
1.3 Operational safety
#
Warning!
If the device is used for any application other than those described in these Operating Instructions,
it may lead to unsafe and improper functioning of the measuring system and is therefore not per-
mitted.
The instruments have been designed and tested according to the state of the art and left the factory
in perfect functioning order. The instruments meet all the prevailing regulations and EC directives
- see "Technical data".
However, always pay attention to the following points:
• Measuring systems used in Ex areas have a separate document (XA 236C/07/a3) which forms a
component part of these Operating Instructions. Always follow the installation regulations and the
- partly deviating - connection data in the Ex documentation as well. You can find the following
symbols on the front page of the additional Ex documentation (depending on approval and test
centre (
0
Europe,
2
USA,
1
Canada).
• The measuring device complies with the general safety requirements in accordance with
EN 61010, the EMC requirements of EN 61326, and NAMUR Recommendation NE 21, 1998.
• The manufacturer reserves the right to change the technical data in line with technical progress
at any time. You can obtain information on the current version of these Operating Instructions
and possible additions from your sales centre.