Endress+Hauser Topclean S CPC30, Руководство по эксплуатации

Страница: 118 / 178

6 Commissioning Topclean S
118 Hauser
Calibration
redox relative "Data entry relative"
Entry of two % calibration points to which one mV value is assigned.
Calibration
redox relative "Calibration relative"
For calibration, two vessels are filled with a sample of the medium. The contents of the first vessel
are detoxified and used as buffer 1.
The contents of the second vessel are left unchanged and used as buffer 2.
CHOICE
(default = bold) INFO
Calibration with rel. data
entry Note in display
Display of the type of on-site calibration selected in the calibration settings.
1. (0...30%):
1. Voltage
2. (70...100%)
2. Voltage 20 %
0600
mV
80 %
-0600
mV Enter calibration points
In this field, create two measured value pairs (pair 1 and pair 2).
Measured value pair 1 in the range 0...30%: assign, for example, the voltage
0600 mV to the percentage value 20 %.
Measured value pair 2 in the range 70...100%: assign, for example, the voltage
–0600 mV to the percentage value 80 %.
The settings made become effective immediately after confirmation with
F
.
Offset too high / too low Note in display:
Error message if the entered offset leaves the maximum range.
Accept
Cancel
Repeat calibration
End of calibration
Accept : Pressing
F
accepts the new calibration data.
Cancel : The data are not accepted, the calibration is not repeated.
Repeat calibration : The data are rejected and a new calibration is started.
Electrode submersed? Note in display:
Is the electrode back in the medium, so that measurement can take place?
CHOICE
(default = bold) INFO
Calibration with rel.
calibration Note in display
Display of the type of on-site calibration selected in the calibration settings.
Immerse electrode in buffer 1 Handling instructions
Immerse the electrode in buffer 1 / 2 (detoxified sample, see above).
Confirm by pressing
F
20 %
(0 ... 30 %)
Enter buffer
Enter the relative redox value of buffer 1 / 2 (detoxified sample) in percent.
Time: 10 s
mV 1:
225
Checks the stability of the calibration
Wait until the measurement is stable:
Time does not count down,
mV value no longer flashes,
Confirm by pressing
F
.
!
Note!
You can set the criteria for the stability check under "
Ñ
> Setup 1 > Calibration >
Cal. settings".
Invalid calibration value Note in display:
Error message if the offset is too large.
Accept
Cancel
Repeat calibration
End of calibration
Accept : Pressing
F
accepts the new calibration data.
Cancel : The data are not accepted, the calibration is not repeated.
Repeat calibration : The data are rejected and a new calibration is started.
Electrode submersed? Note in display:
Is the electrode back in the medium, so that measurement can take place?