Endress+Hauser Topclean S CPC30, Руководство по эксплуатации

Страница: 125 / 178

Topclean S 8 Troubleshooting
Hauser 125
8.1.1 Error number list: Trouble-shooting and configuration
In the following error list, you can find a description of all error numbers.
For each error number there is also information on whether the factory setting (= Fact.) of this error
triggers
• an alarm
• an error current
• cleaning
To enter the error list, proceed as follows:
!
Note!
The second column shows the assignment acc. to NAMUR work sheet NA64 (failure, maintenance,
function control). The NAMUR error with the highest priority is shown in the status field of the
display.
⇒
pH
7.00
Diag
Edit Next
Select
E
Hold
Error list
Error log
Operating log
Calibration log
Validation log
Error
no. NAMUR
class Error message Possible causes / measures Alarm
contact Error
current Automatic
cleaning start
Fact User Fact User Fact User
E001 Failure Memory defective Switch instrument off and on.
If necessary corrective maintenance at factory. yes no – –
E002 Failure Data error in EEPROM yes no – –
E 003 Failure Invalid configuration Repeat download.
E004 Failure Invalid hardware code The new software cannot recognise the module.
E005 Failure Unknown CPG code Topclean S is not recognised.
Topclean S is not compatible to Mycom S
software. yes no – –
E006 Failure Transmitter 1 defective Test with new transmitter yes no – –
E007 Failure Transmitter 2 defective yes no – –
E 008 Failure SCS message sensor 1 Impedance of pH glass membrane too low: check
pH sensor; replace it, if necessary
For ISFET sensors: leak current > 400 nA.
Replace sensor. yes no no
E 010 Failure Temperature sensor 1
defective Check temperature sensor and connections.
ISFET: Check selection in field "Select
temperature sensor". yes no no
E012 Failure CPG communication
failure Check Topclean S connecting cable. yes no no
E013 Failure Assembly has not reached
service position Check assembly position and feedback signals,
Compressed air present?
Check pneumatic lines to the assembly. Assembly
blocked mechanically?
For non-Ex: External power supply 24 V/220V
(not supply from Mycom) present?
Possibly, microfuse is blown. yes no no
E014 Failure Assembly has not reached
measuring position yes no no
E017 Failure Data error in CPC30
EEPROM Switch instrument off and on.
If necessary corrective maintenance at factory. yes no – –