Endress+Hauser Topclean S CPC30, Руководство по эксплуатации

Страница: 45 / 178

Topclean S 5 Operation
Hauser 45
5.1.6 Operation access authorisation
To protect the transmitter against an unintended or undesired change in the configuration and
calibration data, functions can be protected using four-digit access codes.
Access authorisation has the following levels:
Read-only level (accessible without a code):
The complete menu can be viewed. The configuration cannot be altered. No calibration is possible.
Service code Operator level (can be protected by the service code):
This code permits calibration.
Use this code to operate the temperature compensation item. The test functions and the internal
data can be viewed.
Factory setting Code = 0000, i.e. the levels are not protected.
In case you have mislaid/forgotten the entered maintenance code, contact your Hauser
service for a universally valid maintenance code.
Specialist code Specialist level (can be protected by the specialist code):
All menus can be accessed and changed.
Factory setting Code = 0000, i.e. the levels are not protected.
In case you have mislaid/forgotten the entered specialist code, contact your Hauser service
for a universally valid specialist code.
To activate the codes (= functions locked) see the item "PARAM"
➠
"Set up 1"
➠
"Access codes"
(see page 58). Enter your desired code here. If the code is activated, you can only edit the protected
areas with the rights mentioned above.
!
Note!
• Note down the selected code as well as the universal code and keep it in a place where
unauthorised persons do not have access to it.
• If you reset the code to "0000", all levels are freely accessible for editing. The code can only be
reset on the specialist level.
Locking the operation
Unlocking the operation
Pressing
Ï
and
Ð
simultaneously locks the in-field operation of the
instrument.
At the code prompt, the code appears as "9999".
Press
Ò
and
Ñ
simultaneously to unlock the operation.