Endress+Hauser Topclean S CPC30, Руководство по эксплуатации

Страница: 88 / 178

6 Commissioning Topclean S
88 Hauser
6.6.15 Set up 2 – Topclean S
The cleaning processes and cleaning control are set in this menu:
Setting up the programme
Select the appropriate cleaning programme for your measuring point from the stored programmes
in the instrument. You can freely adapt the cleaning programmes to your requirements or deactivate
them as necessary (e.g. the programme steps water, cleaner, additional valve control, number of
repeats and step sequence). In addition, it is possible to configure specially adapted user
programmes.
Control of cleaning programmes
You can choose between the following control types:
•
Automatic : Weekly programme that automatically starts the selected cleaning programme at
every week day. You can freely select between the cleaning programmes.
• Cleaning: Selection of the cleaning programme that is started in the event of an SCS alarm (see
»Set up 2 – Check systems« on page 73) or an error message that has been configured accordingly.
• Power failure programme: Selection of the cleaning programme that is automatically started after
a failure of the power supply or the communication between CPG30 and Mycom S.
• External control: Programmes can be started via an external process control system. The start is
triggered by a 3-bit signal. For the binary coding of individual programmes, see the table on
page 91.
To configure an externally controlled programme, select it in the automatic control types and set
the desired values for water, cleaning agent, etc.
For electrical connection of the binary coding, see the section »External inputs (PCS to CPG30)
and outputs (CPG30 to PCS)« on page 28.
Activating the control types
To activate a control type for cleaning programmes, select "PARAM
➠
Setup 2
➠
Topclean
➠
Activate Topclean" and set the desired control type to "on".
Programme editor
User programme: You can configure your specific cleaning programme in the programme editor.
Selecting the programme
You have a choice of six cleaning programmes in total (see function overview).
• Clean:
This programme is permanently assigned to one function. The cleaning times or repeat cycles are
freely adjustable. You can select and configure this programme within all control types. Note that
the cleaning times, repeat cycles, etc. of the programme are used for all control types. The settings
are also taken over for the Clean Int. programme.
You can start this programme manually (see »Manual operation« on page 102).
• Clean S:
This programme is only available when you are using a Topclean S version with control for an
external valve. It is permanently assigned to one function. The cleaning times or repeat cycles are
freely adjustable. You can select and configure this programme within all control types. Note that
the cleaning times, repeat cycles, etc. of the programme are used for all control types.
You can also start the programme manually (see »Manual operation« on page 102).
• Programmes User 1/2/3:
The user programmes allow you to define the programme sequence freely. A simple way of
programming is to copy predefined programmes to user programmes and adapt them.
To configure these programmes, enter the programme editor and proceed as follows:
1. Edit the programme.
2. Configure the programme.
3. Release the programme.
After having released the programme, you can select it within all control types or start it manually.