Endress+Hauser Topclean S CPC30, Руководство по эксплуатации

Страница: 115 / 178

Topclean S 6 Commissioning
Hauser 115
Calibration
redox absolute "Absolute data entry"
The transmitter has a calibrated mV display range. One absolute mV value is set with a single buffer
solution (adaptation of the measuring chain offset). A buffer solution preferably with 225 or 475 mV
is used.
Electrode status good Note in display:
Electrode status:
There are three status messages for the electrode status: "good", "OK.", "bad". If the
status "bad" is displayed, electrode replacement is recommended to ensure the
quality of the pH measurement.
Accept
Cancel
Repeat calibration
End of calibration
Accept : Pressing
F
accepts the new calibration data.
Cancel : The data are not accepted, the calibration is not repeated.
Repeat calibration : The data are rejected and a new calibration is started.
Waiting for sensor response Communication to the sensor
(digital sensors with Memosens technology only)
Mycom S transmits calibration data to the sensor.
Data saved
Data NOT saved Note in display
(digital sensors with Memosens technology only)
Displays if calibration data were successfully saved to the sensor. If data saving failed,
recalibrate the sensor.
Electrode submersed? Note in display:
Is the electrode back in the medium, so that measurement can take place?
CHOICE
(default = bold) INFO
CHOICE
(default = bold) INFO
Calibration with abs. data
entry Note in display
Display of the type of on-site calibration selected in the calibration settings.
0000 mV
(–1500 ... +1500 mV)
Entry of offset value
Enter the mV value for the electrode offset (electrode offset = deviation of the
measured value display from buffer solution mV value).
Confirm by pressing
F
. The entered value is effective immediately.
The maximum offset is 400 mV.
Offset too high / too low Note in display:
Error message if the entered offset leaves the maximum range.
Accept
Cancel
Repeat calibration
End of calibration
Accept : Pressing
F
accepts the new calibration data.
Cancel : The data are not accepted, the calibration is not repeated.
Repeat calibration : The data are rejected and a new calibration is started.
Electrode in medium? Note in display:
Is the electrode back in the medium, so that measurement can take place?