Endress+Hauser HART Proline t-mass I 300, Руководство по эксплуатации

Страница: 85 / 202

Proline t-mass I 300 HART Commissioning
Hauser 85
Parameter overview with brief description
Parameter Description Selection / User interface / User entry
Assign status input Select function for the status input. • Off
• Reset totalizer 1
• Reset totalizer 2
• Reset totalizer 3
• Reset all totalizers
• Flow override
• Gas group
*
• Zero point adjustment
Terminal number Shows the terminal numbers used by the status input module. • Not used
• 24-25 (I/O 2)
• 22-23 (I/O 3)
Active level Define input signal level at which the assigned function is
triggered. • High
• Low
Response time status input Define the minimum amount of time the input signal level must
be present before the selected function is triggered. 5 to 200 ms
* Visibility depends on order options or device settings
9.4.6 Setting the system units
In the System units submenu the units of all the measured values can be set.
The number of submenus and parameters can vary depending on the device version.
Certain submenus and parameters in these submenus are not described in the
Operation Instructions. Instead a description is provided in the Special Documentation
for the device (→ "Supplementary documentation" section).
Navigation
"Setup" menu → System units
‣
System units
Mass flow unit →  86
Mass unit
→  86
Corrected volume flow unit →  86
Corrected volume unit →  86
Volume flow unit →  86
Volume unit →  86
FAD volume flow unit
→  86
FAD volume unit →  86
Energy flow unit →  86
Energy unit →  86