DECstation 5000/260, Руководство оператора, Страница: 178 / 215

11.3 Is It Connected Properly?
Table 11–2 (Cont.) Solutions to Common Problems
Problem Solution
A TURBOchannel
module for your
workstation does not
appear in the cnfg
display.
1.
If the missing module is a TCE option module, check to see if the
option module in the TCE (to which it is connected) is displayed.
The cnfg display only lists the module in the TCE—not the TCE
option module in the system unit.
2.
Check to make sure that you specified the correct slot number for
the missing module in the cnfg command.
3.
Reinstall the missing option module (see Chapter 9).
An external drive does
not appear in the cnfg
display.
1.
Check to make sure that you specified the correct slot number for
the missing drive in the cnfg command.
2.
Turn off the workstation.
3.
Make sure that the external device in which the missing drive is
located is turned on and connected to an active power source.
4.
Make sure that the external device in which the drive is installed
is properly connected to your workstation (see Chapter 5).
5.
Make sure that the missing drive has a unique SCSI ID from
0 to 6 (see Chapter 5).
6.
If the missing drive is in a TCE or BA42 expansion box, reinstall
the drive inside the box (see the BA42 Installation Guide or
TURBOchannel Extender Operator’s Guide ).
7.
Turn on your workstation and try the cnfg command again.
8.
Remove all the devices except for the one that was missing.
If that device appears, you may have a SCSI cabling or a
termination problem or one of the other devices may be faulty.
If the device is still missing, then that device is bad.
(continued on next page)
Troubleshooting 11–7