DECstation 5000/260, Руководство оператора, Страница: 110 / 215

7.4 Installing a Device with a Modular Connector
7.4 Installing a Device with a Modular Connector
To install a device with a modular (telephone-jack type) connector, you need a
25-pin communications adapter.
1. Follow the instructions that came with your communications device and be
sure that:
• The device is turned off.
• The device is set up and the cable and power cord that came with it are
attached.
• The proper baud rate and control settings on the device and in the
worksystem software are set, if appropriate.
2. Follow the instructions that came with your worksystem software to shut
down the software.
3. Turn off the system unit by pressing the O on the On/Off switch on the
back of the unit.
4. Find the communications connector adapter that came with your shipment
(see Figure 7–2).
5. Hold the adapter so that the widest part of the connector is on top. Press
the 25-pin connector on the adapter into one of the communications
connectors on the system unit and tighten the screws (see Figure 7–4).
External Communications Options 7–7