CTI 2500-C100, Инструкция по установке и эксплуатации

Страница: 95 / 113

CTI 2500 Installation and Operation Guide V2.8 95
STW 200 User Program Error Cause
The following error codes are associated with bit 6 of STW1.
Code Description
0 No Error
1 Unused
2 Unused
3 Unused
4 Subroutine nesting level exceeded
5 Table Overflow
6 Attempt to call a non-existent subroutine
7 Unused
8 SF Program has not been compiled or does not exist
9 SF Program is currently disabled
10 SF Program type is Restricted or Cyclic
11 SF Program or Subroutine is being edited
12 Unused
13 PID Loop is not configured
14 PID Loop is disabled
STW 201 User Program(RLL) First Scan Flags
Bit 1 First Scan After Compile
Bit 2 First scan after Program Mode
Bit 3 First scan after Edit Mode
Bit 4 First scan after Auto Recompile
Bit 5 – 8 Unused
Bit 9 First Scan following a Battery Bad Power Up restart
Bit 10 First Scan following a Battery Good Power Up restart (or power-on start)
Bit 11 First Scan following a Complete Restart
Bit 12 First Scan following a Partial Restart
Bit 13 – 16 Unused
STW 202:
STW 208 Unused
STW 210 Remote I/O Base Poll Enable Flags
The bit corresponding to the base is set to 1 when the base is enabled for
polling.
The most significant bit (1) represents base 15 and the least significant bit (16)
corresponds to the local base (base 0).
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
15 14 13 12 11 10 9 8 7 6 5 4 3 3 1 0