CTI 2500-C100, Инструкция по установке и эксплуатации

Страница: 64 / 113

CTI 2500 Installation and Operation Guide V2.8 64
8.3 System Restart Table
The table below indicates the PLC state after completing the startup operations above.
In the table below N/C designates no change in value.
System Restart Table
Item
Power-Up Restart
Partial
Restart
Complete
Restart
Battery
Off
On
Source=
Flash
1
Source =
RAM
RLL Mode (Run,
Program, Edit
)
RUN Program N/C N/C
2
N/C
2
Loop Mode RUN Program N/C N/C
2
N/C
2
Individual Loop Mode Obtain
from User
Program
Flash Cleared N/C N/C Manual
Discrete I/O (X,Y) Cleared Cleared Cleared Cleared Cleared
Word I/O (WX,WY) Cleared Cleared N/C N/C Cleared
Non-Retentive
Control Relays Cleared Cleared Cleared Cleared Cleared
Retentive Control
Relays Cleared Cleared N/C N/C Cleared
Forced Elements Cleared Cleared N/C N/C N/C
TMR/CNTR/Drum
Presets Restore
from User
Program
Flash RLL Cleared N/C N/C Restore from
ladder
V Memory Cleared Cleared N/C N/C N/C
L,K,S Memory Load From
User
Program
Flash Cleared N/C N/C N/C
Memory Configuration Default N/C N/C N/C
I/O Configuration Cleared N/C N/C N/C
DP Configuration Cleared N/C N/C N/C
DP I/O Mode Stop N/C N/C N/C
DP Synch Mode Asynch N/C N/C N/C
Scan Time / Type Variable N/C N/C N/C
Task Codes /Scan 2 N/C N/C N/C
Password Data Cleared N/C N/C N/C
Time of Day N/C N/C N/C N/C N/C
Scan Watchdog 1 sec 1 sec N/C N/C N/C
Port Lockout Unlocked Unlocked N/C N/C N/C
Fatal Error Cleared Cleared N/C Cleared Cleared
1
. Assumes flash contains a valid program. If not valid, the source is set to RAM (see RAM column).
2
. If controller was in Fatal Error, the controller will start in Program Mode.