CTI 2500-C100, Инструкция по установке и эксплуатации

Страница: 89 / 113

CTI 2500 Installation and Operation Guide V2.8 89
Error Code
(Hexadecimal) Description
18 Requested memory sixe exceeds total available memory
19 Requested memory size is not multiple of block allocation size
1A Requested memory size is less than minimum defined value
1B Requested memory size is larger than maximum defined value
1C PLC busy – cannot complete requested operation
1D Communications error in HOLD mode – Transition to Run not
allowed
1E Port Lockout is active
1F Attempting to delete active program via reconfiguration
20 Program load in progress or invalidated
21 I/O configuration error –too many points
22 I/O configuration error – attempt to assign Output point to multiple
applications
23-3E Unused
3F Bus error detected
40 Operating system error detected
41 Invalid control block type
42 Control block number out of range
43 Control block does not exist
44 Control Block already exists
46 Offset out of range
47 Arithmetic error detected while writing Loop or Loop Alarm
parameters
48 Invalid SF program type
49 Instruction number or RAMP/SOAK step number out of range
4A Attempt to access an integer variable as a real
4B Attempt to access a real variable as an integer
4C Trask code buffer overflow – too much data requested
4D Control block size error (cannot exceed 32767 bytes)
50 Task code request buffer too large
51 Invalid SF statement size
52 Invalid return value
53 Attempt to execute a cyclic statement in a non-cyclic SF program
54 Control block is disabled
55 Control block is not disabled
56 Attempt to perform a FSTR_OUT SF statement on an empty FIFO
57 Attempt to perform a FSTR_INT SF statement on a full FIFO
58 Stack overflow while evaluating a MATH, IF-THEN, or IMATH
statement
59 Maximum SF subroutine nesting level exceeded (maximum = 4)
5A Arithmetic Overflow
5B Invalid operator in and IF, MATH, or IMATH expression
5C S memory overflow
5D Attempt to divide by 0
60 Invalid data type code
61 RAMP/SOAK step type mismatch