CTI 2500-C100, Инструкция по установке и эксплуатации

Страница: 36 / 113

CTI 2500 Installation and Operation Guide V2.8 36
4.2 I/O Support
The CTI 2500 controller supports CTI 2500 Series 2500 I/O products, Siemens Series 505
®
and
Siemens Series 500 I/O
®
products, and Profibus DP I/O products. CTI 2500 Series I/O modules
and Siemens Series 505
®
I/O modules can be installed in the same rack as the CTI 2500
controller or installed in a remote base which is attached to the controller via a communications
link. Series 500
®
I/O must be installed in a remote base.
4.2.1 CTI 2500 Series I/O
CTI provides a full range of I/O products including discrete input/output modules, analog
input/output modules, serial and Ethernet communications modules, and specialty modules,
such as vibration recording modules and warm backup modules. In addition, CTI provides
remote base racks and remote base controllers. For a complete list of CTI products, log on to
the CTI Web site (
www.controltechnology.com ).
4.2.2 Siemens SIMATIC 505
®
and Series 500
®
I/O Support
The CTI 2500 controller supports most current SIMATIC Series 505
®
discrete and analog I/O
modules. In addition, the controller will also interoperate with designated non-CTI Special
Function modules. See the CTI Web Site for a list of supported Siemens Series 505 products.
The controller will communicate with the following Siemens SIMATIC
®
remote base controllers:
•
505-6851 and 505-6851A (RS-485)
•
505-6850 and 505-6850A (Coax)
When using SIMATIC 505-6850 or 505-6850A remote base controllers, you must attach the
RBC to the CTI 2500 using a Siemens SIMATIC 505-6860 I/O Channel Converter.
The CTI 2500 controller supports designated Siemens Series 500
®
discrete, analog I/O
modules, and Special Function modules. See the CTI Web Site for a list of supported Series
500
®
Products.
The CTI controller will communicate with Siemens Series 500
®
I/O installed in a remote base
using the following Remote Base Controllers:
•
500-5114 and 500-5114A (RS-485)
•
500-2114 and 500-2114A (Coaxial)
When using a 500-2114 or 500-2114A, you must attach the RBC to the CTI 2500 controller
using a Siemens 505-6860 I/O Channel Converter.
4.2.3 Connecting to Remote I/O
Remote I/O is connected to the CTI 2500 controller via RS-485 cable. Cabling is typically
connected in a trunk line/ drop line arrangement as shown below.