CTI 2500-C100, Инструкция по установке и эксплуатации

Страница: 87 / 113

CTI 2500 Installation and Operation Guide V2.8 87
Code Description Correction
0300 Operating System Error
Indicates that an error has been
detected in the operation of the system
firmware.
Error details can be obtained from the system
event log.
If this error persists, contact CTI product support.
0400 Diagnostic Error
Indicates that a general diagnostic error
has occurred.
Error details can be obtained from the system
event log.
0600 Hardware Failure
Indicates that a failure in a hardware
component has been detected.
Error details can be obtained from the system
event log.
0608 System Clock Failure.
Indicates the system clock cannot be
accessed.
To clear this error you must cycle power to the
controller. If the problem persists, contact CTI
Product Support.
060b L Memory Invalid: Power loss during in-
progress RLL edit operation. After clearing this error, you must reload the user
program.
060C L Memory Invalid: Power loss during L
memory resize operation After clearing this error, you must reload the user
program.
060d S Memory Invalid: Power loss during in-
progress S memory edit operation. After clearing this error, you must reload the user
program.
060F System service failure. To clear this error, you must cycle power to the
controller. If the problem persists, contact CTI
Product Support.
0611 RLL Source checksum error detected
during power-up start.
Indicates that the RLL is invalid and
cannot be compiled.
After clearing the fatal error using Partial or
Complete Restart, you must reload the user
program to prevent this error from re-occurring.
0612 S Memory checksum error detected
during power-up start.
Indicates the Special Function source is
invalid and cannot be compiled.
After clearing the fatal error using Partial or
Complete Restart, you must reload the user
program to prevent this error from re-occurring.
0615 Startup RLL compile failed
Indicates the RLL failed to compile
during a power-on start
Error details can be obtained from the system
event log.
After clearing the fatal error using Partial or
Complete Restart, you will need to correct RLL
errors before it will compile.
0616 Startup SFP/SFS compile failed
Indicates at least one SFP or SFS failed
to compile during a power-on start.
Error details can be obtained from the system
event log.
After clearing the fatal error using Partial or
Complete Restart, you will need to correct the
SFP or SFS error and re-enable the program or
subroutine.
0618 I/O Interface Timeout
Indicates the I/O interface failed to
respond to a request from the main
processor.
Clear the error using Partial or Complete Restart.
If this error persists, contact CTI product support.