CTI 2500-C100, Инструкция по установке и эксплуатации

Страница: 94 / 113

CTI 2500 Installation and Operation Guide V2.8 94
STW 168 Dual RBC Status (Remote I/O)
Status of 0 indicates that the dual RBCs are present and good. 1 indicates a
bad RBC or a single RBC. The most significant bit (1) represents base 15 and
the least significant bit (16) represents the local base (0).
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
15 14 13 12 11 10 9 8 7 6 5 4 3 3 1 0
STW 169:
STW 175 Unused
STW 176 Redundant Power Supply Status
Status of 0 indicates that the base is present, dual supplies are present, and
they are both good. Status of 1 indicates that a power supply is bad or only a
single power supply is present. The most significant bit (1) represents base 15
and the least significant bit (16) represents the local base (0).
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
15 14 13 12 11 10 9 8 7 6 5 4 3 3 1 0
STW 177:
STW 183
Unused
STW 184 Module Mismatch or Unclaimed MODFAIL signal
Bit 1 Set to 1 if there is a module mismatch on any base
Bit 2-4 Unused
Bit 5 – 8 Number of base with mismatch
Bit 9 - 16 Unused
STW 185:
STW 190
Unused
STW 191 Serial Port Print Status
Bit 1 Print Busy – The port is currently sending characters from the print buffer
Bit 2 Configuration Error - The serial port is not configured for print output. The print
jumper is missing or is in the wrong position.
Bit 3 Print Buffer Overflow – The buffer is full, additional characters have been
discarded
Bit 4 Hardware Error – Serial port UART failure
Bit 5 - 16 Unused
STW 192 Discrete Execution Scan Time
Indicates the time spent in the last discrete scan cycle.
STW 193:
STW 199
Unused