CTI 2500-C100, Инструкция по установке и эксплуатации

Страница: 21 / 113

CTI 2500 Installation and Operation Guide V2.8 21
2.1.4 Choosing the IP Address and related Parameters
Before you can use the Ethernet port, you must set the IP address, network mask, and the
default router. If you already have a network installed, you should contact your network
administrator to determine the values to be used. See APPENDIX C. – IP ADDRESS
INFORMATION for more information on choosing an IP address. The IP address can be set via
the serial or USB port using PLC Workshop (version 4.11 and above) or by IPSET, a utility
program provided by CTI. Firmware version 8.02 and above allows you to set the IP address
via the Ethernet port using PLC workshop or the controller embedded web server. See Section
7.4 for additional information.
2.1.5 Power Requirements
The CTI 2500 module consumes 5.5 watts of +5 VDC power. To calculate the total power
required for the base, you need to add the power requirements for the other modules you will
install in the base.
2.2 Unpacking the Controller
Open the shipping carton and remove the special anti-static bag that contains the controller.
After discharging any static build-up, remove the unit from the static bag. Do not discard the
static bag; use it for protection against static damage when the module is not inserted into the
I/O base.
CAUTION
The components on the CTI 2500 controller printed circuit card can be damaged by static
electricity discharge. To prevent this damage, the module is shipped in a special anti-static bag.
Static control precautions should be followed when removing the module from the bag and when
handling the printed circuit card during configuration.