Chevrolet 1977 Monte Carlo, Руководство по ремонту

Страница: 339 / 428

A U T O M A T IC T R A N S M IS S IO N S (4 0 0 )7 A -53
Fig.
7 A - 1 7 1 C - - l n s t a l l i n g E x t e n s i o n Oi l S e a l ( T y p i c a l )
2. A ttach extension housing to case using attaching
bolts a n d /o r studs. Torque bolts to 20-25 ft. lbs.
3. If necessary, install a new seal as follows:
a. (A ll except CL M odels) use a non-hardening sealer
on outside o f seal body; and using T ool J -2 1359, drive seal
in place (Fig. 7A -171C ).
b.
(M od el C L ) use a non-hardening sealer on outside
o f seal body; and using T ool J-24057 drive seal in place (Fig.
7A -171C ).
Fi g. 7 A - 1 7 3 C - - L o c a t i o n o f C h e c k B a I ls--l n V e h i c l e I n s t a l l a t i o n
Installation of Check Balls, Control Valve
Spacer Plate and Gasket
Detent Solenoid, Front Servo Assembly, and
Electrical Connector
1. Install tw o control valve assem bly attaching bolts
with heads cut o ff as guide pins as show n in figure 7A -183C .
2. Install six (6) check balls into ball seat pockets in
transm ission case. Figure 7A -172C . If transm ission is in the
vehicle, install check balls into ball seat pockets on spacer
plate (Fig. 7A -173C ).
3. Install control valve spacer p late-to-case gasket
(gasket with extension for detent solenoid and a " C" near
front servo location) (Fig. 7A -174C ).
SPACER PLATE
GASKET
F ig . 7 A - 1 7 2 C - - L o c a t i o n o f C h e c k B a l l s Fi g. 7 A - 1 7 4 C - - l n s t a l l i n g C o n t r o l V a l v e A s s e m b l y S p a c e r P l a t e
a n d G a s k e t
6 CHECK BALLS