Chevrolet 1977 Monte Carlo, Руководство по ремонту

Страница: 184 / 428

7A1-16 AUTOMATIC TRANSMISSION (200)
3. Position speedom eter gear, larger chamferred inside
diameter first, over rear end o f output shaft. (Figure 7A 1-
74).
4. Using T ool J-28578 drive gear to 156.15mm (6 -5 /
32") from rear end o f output shaft to rear face o f gear.
J-8433
Figure 7A 1-70 Installing Manual Shaft Into Case
SPEEDOMETER
D R IV E GEAR
J-21427-01
Figure 7A 1-73 Removing Speedo Gear (Steel)
S P E E D O M E T E R
D R I V E G E A R C L I P
S P E E D O M E T E R
D R I V E G E A R
O U T P U T S H A F T
907A7
R
Figure 7A1-71 Output Shaft
1. R em ove roller clutch race. Inspect race and spline
for scoring or wear. (Figure 7A 1-77).
2. R em ove roller clutch assem bly and inspect roller
bearings, cage and springs for dam age or wear. (Figure 7A 1-
77).
3. R em ove and inspect rear carrier to roller clutch
thrust washer for signs o f scoring or excessive wear. (Figure
7A 1-77).
4. Inspect 4 tanged rear carrier to rear internal gear
thrust w asher for being scored or distorted tangs. (Figure
7A 1-77)
5. Inspect rear carrier for damage. (Figure 7A 1-77).
6. Inspect roller clutch cam ramps for damage.
SPEEDOMETER
DRIVE GEAR CLIP
Figure 7A1-72 Installing Plastic Speedometer Driven Gear and
Clip
Rear Internal Gear
1. Inspect rear internal gear, splines, teeth and bearing
surface for wear, cracks or damage.
2. Inspect parking pawl lugs for cracks or damage.
3. Install rear internal gear, hub end first, on output
shaft, as show n in Figure 7A 1-76.
4. Thoroughly clean, air dry and inspect closely, the
rear internal gear to rear sun gear roller thrust bearing
assembly for pitted or rough conditions.
SPEEDOMETER
DRIVE GEAR
7B7A518
OUTPUT SHAFT
J-28578
SPEEDOMETE
DRIVE GEAR
Figure 7A1-74 Installing Speedo Gear (Steel)
5. Install rear internal gear to rear sun gear roller thrust
bearing assembly by placing the sm all diam eter race over
the output shaft. (Figure 7A 1-75).
Roller Clutch and Rear Carrier
Assembly