Chevrolet 1977 Monte Carlo, Руководство по ремонту

Страница: 334 / 428

(400)7A -48 A U T O M A T IC TR A N S M IS S IO N S
F ig . 7 A - 1 5 0 C ~ l n s t a l l i n g R o l l e r C l u t c h t o R e a c t i o n C a r r i e r
18. Install roller clutch assem bly (Fig. 7A -150C ) into
reaction carrier.
19. Install center support to reaction carrier thrust
washer into recess in center support. R etain w ith petrolatum
(Fig. 7A -47C ).
20. Install center support into roller clutch in reaction
carrier (Fig. 7A -151C ). W ith reaction carrier held, center
support should only turn counter-clockw ise after
installation. See Fig. 7A -152C for check o f roller clutch.
21. Install J -2 1795 on gear unit assem bly to hold units
in place.
22. Install output shaft to case thrust w asher tabs in
pockets (Fig. 7A -152C ), and retain w ith petrolatum . This
m ust be a m etal washer.
A S S E M B L Y OF U N IT S TO T R A N S M IS S IO N
CASE
The first three steps can be om itted if the parts involved
were not rem oved on disassem bly.
1. Install parking pawl tooth toward inside o f case, and
parking pawl shaft (Fig. 7A -154C ).
2. Install parking pawl shaft retainer clip (Fig. 7A -
155C).
F i g . 7 A - 1 5 2 C - - C h e c k i n g R o l l e r C l u t c h R o t a t i o n
F ig . 7 A - 1 5 3 C - l n s t a l l i n g C a s e t o O u t p u t S h a f t T h r u s t W a s h e r
ROLLER CLUTCH
ASSEMBLY
THRUST WASHER
(METAL)
Fig. 7 A - 1 5 1C—Installing Center Sup po rt to Reaction Carrier Fig. 7A-154C--lnsta lling Parking Pawl Shaft Cup Plug