Brother PE-Design Next, Инструкция по эксплуатации

Страница: 200 / 320

198
Figure Handle Stage
Figure Handle Stage
Changing settings for
converting to outlines
1.
In the Line Image Stage, click 1 .
c
“Line Image Stage” on page 186.
2.
Specify the desired settings in the Figure
Object Conversion Setting dialog box, and
then click OK .
(1) Select a setting under Resolution .
Fine: Select this setting only if the image
contains many small details.
Normal: Select this setting to provide a
sufficient resolution without making the
file too large.
Coarse: Select this setting to keep the file
as small as possible.
(2) To replace the black outlines with figure
handle lines along the center of the
outlines, select the
Thinning Process
check box, and then use the slider to
select the degree of detail.
To replace the black lines with figure
handle lines following the border of the
outlines, clear the
Thinning Process
check box.
(3) Use the SIZE slider to set the size.
(4) You will not be able to enlarge the image
beyond the limits of the Design Page
area. If necessary, click
Design Page
Property , and then change the Design
Page size.
(5) To create outline data from a part of the
image, select the specific area by clicking
Pick Area , then dragging the pointer (+)
to draw a selection frame around the area
to be selected.
b
Memo:
When the slider is set to Much , even very
thick black lines will be replaced with a line
along the center.
1
(4)
(1)
(2)
(3)
(5)
ON
OFF
XE8656-001.book Page 198 Monday, May 24, 2010 5:44 PM