Yamaha WR426F(N), Owner'S Service Manual

Page: 220 / 762

2 - 39
SPEC
CABLE ROUTING DIAGRAM
È
Fasten the TPS lead (in the
sub wire harness) under the
frame so that it does not con-
tact the carburetor.
Ô
Fasten the TPS lead under the
coupler to the frame with a
plastic locking tie.

Pass the carburetor breather
hose and overflow hose
between the connecting rod
and cross tube (frame).
Ò
Fasten the neutral switch lead
and oil hose together with a
plastic locking tie.
˜
Fasten the neutral switch lead
to the frame with a plastic
band.
ˆ
Fasten the cylinder head
breather hose with the hose
holder.
Ø
Fasten the neutral switch lead
and CDI magneto lead
together with a plastic band.
∏
Pass the clutch cable through
the cable guide.
Œ
Pass the cylinder head
breather hose along the inner
side of the radiator pipe.
Â
Pass the clutch cable between
the frame and radiator and
over the lower boss on the
radiator.
Í
Pass the neutral switch lead
and CDI magneto lead over
the middle radiator mounting
boss. Then, pass the decom-
pression cable under the mid-
dle radiator mounting boss
and along the left side of the
neutral switch lead and CDI
magneto lead.
Ê
Pass the clutch cable through
the cable guide.
Ë
Fit the brake hose into the
guide on the protector.
◊
Fasten the ignition coil lead
(in the sub wire harness) on
the upper inside of the frame
and cut off the tie end.
„
Pass the ignition coil lead (in
the sub wire harness) under
the cushion bracket (frame).
≈
Fasten the ignition coil lead
(in the sub wire harness) to
the frame with a plastic lock-
ing tie and cut off the tie end.
Á
Pass the carburetor breather
hoses and overflow hose so
that all there hoses do not
contact the rear shock
absorber.