LOWR
Lower unit
8-29
Installing the propeller shaft housing
assembly
Do not reuse an O-ring, always replace it
with a new one.
1.
Install new O-rings to the propeller shaft
housing.
2.
Set the shift rod joint
1
and dog clutch
2
to the N position.
3.
Install the washer
3
and propeller shaft
assembly
4
into the propeller shaft
housing assembly
5
.
4.
Install the propeller shaft housing assem-
bly, and then tighten the propeller shaft
housing bolts
6
to the specified torque.
5.
Install the cover
7
.
6.
Install the water inlet covers
8
, and then
tighten the water inlet cover screw
9
to
the specified torque.
Installing the shift rod
Do not reuse an oil seal or O-ring, always
replace it with a new one.
1.
Check that the shift rod joint is in the N
position, and then install the shift rod
1
,
the spring
2
, a new O-ring
3
, the plate
4
, and a new oil seal
5
.
Drive shaft holder 6
6
: 90890-06520
Pinion nut holder
7
: 90890-06715
Pinion nut:
142 N·m (14.2 kgf·m, 104.7 ft·lb)
6
7
7
F
N
R
1
2
3
4
5
2
Propeller shaft housing bolt
6
:
29 N·m (2.9 kgf·m, 21.4 ft·lb)
Water inlet cover screw
9
:
1 N·m (0.1 kgf·m, 0.7 ft·lb)
7
6
9
8
Summary of Contents for F200B
