Yamaha F200B, Service Manual

Page: 271 / 579

7-12
7
5. Install the cover
7
and aprons
8
.
TIP:
Make sure that the ground lead
a
is routed
through the gap between the aprons and is
not pinched.
6. Connect the PTT relay terminals
b
, and
then tighten the PTT relay terminal bolts
9
to the specified torque.
7. Install the caps 0 , and then fasten the
PTT motor lead
c
using the plastic tie A
and holders
B
.
TIP:
To fasten the PTT motor lead, see “Wiring
harness routing” (5-6).
8. Connect the cooling water hose C , and
then fasten it using the clamp
D
.
9. Fasten the cooling water hose C using
the holder E .
10. Connect the neutral switch coupler
d
,
and then install the neutral switch coupler
to the bracket
F .
11. Connect the shift cut switch coupler
e
.
12. Fasten the neutral switch lead and wiring
harness using the holder G and H .
13. Install a new O-ring and the dipstick
guide I , and then install the dipstick J .
14. Install the intake manifold (STBD). See
“Installing the intake manifold” (6-18).
PTT relay terminal bolt 9 :
4 N·m (0.4 kgf·m, 3.0 ft·lb)
8
7
8
a
STBD
9
b
b
0
0
B
A
c
B
G
H
I
J
E C D
F
e
d
Power unit assembly