Yamaha F200B, Service Manual

Page: 244 / 579

6-35
FUEL
Fuel system
Draining the fuel
1. Remove the flywheel magnet cover.
2. Remove the intake silencer. See
“Removing the intake silencer” (6-17).
3. Disconnect the fuel hose
1
from the
vapor separator assembly.
4. Loosen the vapor separator drain screw
2
to drain the fuel into a drain pan.
5. Tighten the vapor separator drain screw
2
to the specified torque.
6. Connect the fuel hose to the vapor sepa-
rator assembly.
7. Install the intake silencer. See “Installing
the intake silencer” (6-19).
8. Install the flywheel magnet cover.
Removing the vapor separator
Cover the fuel components using a rag to
prevent fuel from spilling out.
1. Disconnect the quick connector. See
steps 3–5 in “Disconnecting the quick
connector” (6-7).
2. Remove the vapor separator wiring har-
ness extension
1
.
3. Remove the vapor separator assembly
2
, and then remove the cooling water
hoses
3
and
4
and joint
5
.
Installing the vapor separator
1. Install the joint
1
to the cooling water
hose
a
, and then fasten the cooling
water hose using the clamp
2
.
2. Install the cooling water hose
3
, and
then fasten it using the plastic ties
4
.
3. Install the cooling water hose
5
, and
then fasten it using the clamp
6
and
plastic tie
7
.
4. Install the vapor separator assembly
8
.
Vapor separator drain screw
2
:
2 N·m (0.2 kgf·m, 1.5 ft·lb)
2
1
1
1
4
4
5
2
3
3