7-40
7
TIP:
Before installing the timing belt, make sure
that the marks on the crankshaft and cylinder
block are aligned. Also, make sure that the
marks on the VCT assemblies and driven
sprockets are aligned. See steps 6 and 7 in
“Removing the timing belt” (7-38).
3.
Install the timing belt onto the VCT
assemblies and driven sprockets by
aligning belt position marks
e
,
f
,
g
,
and
h
with the “
L
L
L
L
” marks in the order
listed.
k
Belt teeth number
4.
Install the collar
6
, push the timing belt
inward using the pulley
7
, and then
install the pulley.
NOTICE:
Make sure
that the pulley
7
is installed properly
onto the collar
6
.
5.
Install the washer, and then tighten the
pulley bolt
8
to the specified torque.
TIP:
When installing the pulley, make sure to keep
the belt position marks and the “
L
L
L
L
” marks
aligned as specified in step 3.
6.
Adjust the timing belt installation height
m
to specification.
7.
Insert a hexagon wrench into the hole
n
,
turn the timing belt tensioner gradually
clockwise, remove the pin
9
, and then
return the timing belt tensioner slowly.
160
133
88
60
0 1 2 3
c
h
g
f
e
k
h
g
f
e
Pulley bolt
8
:
39 N·m (3.9 kgf·m, 28.8 ft·lb)
Timing belt installation height
m
:
2.0 mm (0.08 in)
7
8
6
m
9
n
Summary of Contents for F200B
