9-4
9
Assembling the shift bracket
1.
Install the neutral switch
1
and plate
2
,
and then tighten the neutral switch
screws
3
to the specified torque.
2.
Fasten the neutral switch lead
a
using
the plastic tie
4
.
3.
Install the grease nipple
5
, and then
tighten it to the specified torque.
4.
Install the shift cut switch
6
and plate
7
,
and then tighten the shift cut switch
screws
8
to the specified torque.
5.
Install the bushings
9
and spring
0
onto
the bracket
A
.
6.
Fit the spring end
b
into the slot in the
bracket
A
and the spring end
c
into the
slot in the bracket
B
.
7.
Turn the bracket
B
to position
d
, push it
down, and then tighten the shift bracket
bolt
C
to the specified torque.
NOTICE:
Before pushing the bracket
B
down,
move the shift cut switch lever
e
in
direction
f
. Otherwise, the lever
could be damaged.
Installing the shift rod and shift
bracket
1.
Install the bushings
1
, bracket
2
, and
washer
3
, and then install a new cotter
pin
4
.
2.
Install the ball
5
and spring
6
, and then
tighten the shift rod detent bolt
7
to the
specified torque.
Neutral switch screw
3
:
2 N·m (0.2 kgf·m, 1.5 ft·lb)
Grease nipple
5
:
1 N·m (0.1 kgf·m, 0.7 ft·lb)
Shift cut switch screw
8
:
2 N·m (0.2 kgf·m, 1.5 ft·lb)
2
3
4
1
a
7
8
6
5
Shift bracket bolt
C
:
19 N·m (1.9 kgf·m, 14.0 ft·lb)
b
c
9
9
0
A
A
B
B
C
B
e
d
B
f
Summary of Contents for F200B
