Yamaha F200B, Service Manual

Page: 391 / 579

8-28
8
2. Install new oil seals into the oil seal hous-
ing to the specified depth
b
.
TIP:
Install an oil seal halfway into the oil seal
housing, and then the other oil seal.
Installing the drive shaft
Do not reuse a bearing or O-ring, always
replace it with a new one.
1. Install the forward gear assembly into the
lower case.
2. Install the drive shaft 1 , thrust bearing
2 , and original pinion shims 3 .
3. Install the pinion and washer, and then
tighten the pinion nut temporarily.
TIP:
When installing the pinion, lift up the drive
shaft slightly and align the splines on the
drive shaft with the splines on the pinion.
4. Install a new O-ring
4
to the oil seal
housing
5
, and then install the oil seal
housing
5
.
TIP:
Make sure to install the oil seal housing
5
so
that the notch
a
is facing forward.
5. Tighten the pinion nut to the specified
torque.
Depth
a
:
4.25–4.75 mm (0.167–0.187 in)
Bearing outer race attachment 3 :
90890-06628
Driver rod LS 4 : 90890-06606
Depth
b
:
0.25–0.75 mm (0.010–0.030 in)
3
4
b
2
3
1
4
5
a
Drive shaft and lower case (F200B)