7-44
7
Removing the cylinder head cover
1.
Remove the ignition coils
1
, spark plugs
2
, cam position sensors
3
and
4
, and
adapter
5
, and then remove the cylinder
head covers
6
and
7
.
2.
Remove the cylinder head cover plate
8
from the cylinder head cover (STBD)
7
.
Checking the spark plug
1.
Clean the electrodes
a
using a spark
plug cleaner.
2.
Check the spark plug. Replace if the
electrodes are eroded, or there is carbon
or other deposits.
3.
Check the spark plug gap
b
. Replace if
out of specification.
Installing the cylinder head cover
• Do not reuse a gasket or O-ring, always
replace it with a new one.
• When the timing belt is not installed, do
not turn the crankshaft or driven sprock-
ets. Otherwise, the pistons and valves
or intake and exhaust valves could col-
lide with each other and be damaged.
1.
Install the cylinder head cover plate
1
to
the cylinder head cover (STBD)
2
, and
then tighten the cylinder head cover plate
screws
3
to the specified torque.
1
1
1
1
2
2
3
4
3
6
5
7
8
7
Specified spark plug: LFR6A-11 (NGK)
Spark plug gap
b
:
1.0–1.1 mm (0.039–0.043 in)
a
b
Summary of Contents for F200B
