Yamaha F200B, Service Manual

Page: 395 / 579

8-32
8
È
U-transom model
TIP:
Point the flat end of the stud bolt 9 up.
6. Install the propeller 0 , place a block of
wood between the anti-cavitation plate
and propeller to keep the propeller from
turning, and then tighten the propeller nut
A to the specified torque.
7. Install a new cotter pin B .
TIP:
If the slots in the propeller nut A are not
aligned with the cotter pin hole, tighten the
propeller nut
A until they are aligned.
8. Fill the lower unit with gear oil up to the
proper level. See steps 5–8 in “Changing
gear oil” (10-11).
Lower case mounting bolt
5
:
47 N·m (4.7 kgf·m, 34.7 ft·lb)
Lower case mounting nut
6
:
47 N·m (4.7 kgf·m, 34.7 ft·lb)
Trim tab bolt
8
:
42 N·m (4.2 kgf·m, 31.0 ft·lb)
È
2
2
6
5
7
8
4
5
9
3
5
A
0
Propeller nut
A
:
55 N·m (5.5 kgf·m, 40.6 ft·lb)
B
A
Drive shaft and lower case (F200B)