4-4
4
(*1) Intake air pressure
(*2) This item shows the target output voltage of the TPS.
This value is the control voltage that the engine ECM requires to set the target opening
angle of the throttle valve.
(*3) Reference TPS voltage
This item shows the criterion output voltage of the TPS.
This value is used to detect the TPS output voltage during engine operation.
(*4) Reference APS voltage
This item shows the criterion output voltage of the APS.
This value is used to detect the APS output voltage when the remote control lever is
opened.
(*5) Engine ECM controls the engine idle speed using the throttle valve that is connected to the
TPS.
This target voltage is used by the engine ECM to obtain the target opening angle of the
throttle valve at engine idle speed.
(*6) Engine shut-off switch
(*7) Main relay (ignition coil, fuel injector, VCT, engine ECM, low-pressure fuel pump, high-
pressure fuel pump, vapor shut-off valve, and YDIS)
(*8) Low engine oil pressure
Summary of Contents for F200B
