Yamaha F200B, Service Manual

Page: 381 / 579

8-18
8
Assembling the propeller shaft
housing assembly
• Use heat-resistant gloves. Otherwise,
burns could result.
• To prevent fires, remove any flammable
substances, such as gasoline and oil,
around the working area.
• Keep good ventilation while working.
Do not reuse a bearing or oil seal, always
replace it with a new one.
1. Install a new needle bearing
1
to the
specified depth
a
.
TIP:
• Face the bearing identification mark
b
on
the needle bearing 1 toward the propeller
side.
• When using the special service tool
2
, do
not strike it in a manner that will force the
stopper
c
out of place.
2. Install new oil seals into the propeller
shaft housing to the specified depth
d
.
TIP:
Install an oil seal halfway into the propeller
shaft housing, and then install the other oil
seal.
3. Install a new ball bearing
6
and original
reverse gear shims
7
.
TIP:
• Do not reuse a shim if deformed or
scratched.
• Face the bearing identification mark
e
on
the ball bearing 6 toward the propeller
side.
Driver rod SS
2
: 90890-06604
Needle bearing attachment
3
:
90890-06610
Bearing depth plate
4
: 90890-06603
Depth
a
:
25.05–25.55 mm (0.986–1.006 in)
4
a
c
2
3
b
1
Bearing inner race attachment
5
:
90890-06640
Depth
d
:
4.75–5.25 mm (0.187–0.207 in)
Needle bearing attachment
8
:
90890-06654
d
5
8
7
6
e
Propeller shaft housing (F200B)