Xerox ColorQube 9301, User Manual

Page: 201 / 260

Device Settings
ColorQube 9301/9302/9303 Multifunction Printer
User Guide
201
• Change Description is used to specify the paper type and color. It is important that this setting
matches the paper type and color loaded in the printer. Select the appropriate Paper Type and
Color setting and select Save .
• Repeat the process for each of the trays, as required.
Timers
Select the Timers option to access the following settings:
• Auto Resume Timer on page 201
• Held Job Timeout on page 201
• System Timeout on page 201
Auto Resume Timer
If the printer is stopped during a job execution, this feature determines if the printer automatically
resumes the job after a set period of time or if it waits for user intervention to resume the job. This can
prevent a user leaving the printer in a stopped or paused state.
•
Auto Resume is selected to automatically resume stopped operations at the designated time.
Select the period of time the printer waits for before resuming, 15 –120 seconds, using the arrow
buttons.
• Wait for User instructs the system to remain stopped until a user selects Resume or Cancel .
Held Job Timeout
Use this option to enable the printer to delete jobs that have been held in the job list for a specified
period of time and have been abandoned by a user. email, network scanning, incoming server fax,
embedded fax, and Internet fax jobs are not affected by this setting.
•
Enable allows the printer to automatically delete held jobs after a specified period, set the period
of time, 0–120 hours and 0–59 minutes, using the arrow buttons.
• Disable instructs the printer not to delete held jobs from the job list. The held jobs are deleted
only if the printer is switched off.
System Timeout
Use this option to set the printer to return to the default screen and feature settings after a specified
period of time. This option enables the system administrator to define the timeout period by using
CentreWare Internet Services or the UI. After the timeout on the UI, the screen appears the same as it
does after pressing Clear All , log out, or remove a partial job.
• Select Enable to instruct the printer to time out after a specified period. Select the time period,

0–60 minutes, using the slide bar.
•
The time range should be 0–45 seconds in 15-second increments.
• There is always some timeout for security reasons.
• When the timeout reaches the specified limit, a system timeout screen will appear, letting the user
know that the session will time out in 5 seconds and asking if the user would like to continue. For
further information, refer to the
System Administrator Guide
.
• Select Disable if you do not want the printer to automatically return to the default settings after
the specified period of time.