Xerox ColorQube 9301, User Manual

Page: 174 / 260

Tray 4
ColorQube 9301/9302/9303 Multifunction Printer
User Guide
174
Tray 4
Tray 4, or Bypass, is a paper tray on the left-hand side of the printer and can be folded away when not
in use. It is primarily intended for use as a small quantity, special materials feeder and accommodates
media of all types, including transparencies, envelopes, and tabs.
When media is detected in Tray 4, a paper settings screen is displayed. The drop-down menus are used
to change the size, type, and color of the loaded media. The guides automatically detect the size of the
media loaded, and the printer gives a warning if the guides are not set correctly or a non-standard
paper size is used. The following media can be loaded in Tray 4 (Bypass):
•
Up to 100 sheets of 75 g/m², or 20 lb paper.
• Weights ranging from 60 g/m² to 216 g/m² (16–56 lb).
• Media sizes ranging from A5 SEF to SRA3 SEF (5.5 x 8.5 in. SEF to 12x18 in. SEF). Envelope sizes
ranging from DL to C4 (#10 to 9 x 12 in.) must be fed in the SEF orientation.
• Media types:
•
Bond, standard, or recycled paper
• Card
• Pre-printed media
• Labels
• Transparencies
• Hole-punched paper
• Carbonless paper
• Tabs
• Envelopes
Note: For 80 g/m², paper capacities are slightly lower than specified.
Loading Tray 4
The printer alerts you if Tray 4 is selected for a job and the media requested does not match the media
currently loaded. The printer also warns you if the tray runs out of paper during a job.
1. Make sure the tray is in the down
position. For larger media, use the tray
extension.
2. Place the media on the tray. Locate
the media to the right edge.
•
Load pre-printed paper and
labels face down and with their
top toward the front of the
printer.
• Load hole-punched paper with
the holes on the left.
• Load transparencies face down with the white strip on the left.
For information about loading tabs, refer to Pre-Cut Tabs on page 181.
Paper must not be loaded above the maximum fill line.