Xerox ColorQube 9301, User Manual

Page: 173 / 260

Tray 3
ColorQube 9301/9302/9303 Multifunction Printer
User Guide
173
Tray 3
Tray 3 is a high-capacity tray. It is intended to be the primary feeder for the most commonly used
media. This tray is permanently set as a dedicated tray and feeds only A4 or 8.5 x 11 in. LEF-sized
media. The following media can be loaded in Tray 3:
•
Up to 2,100 sheets of 75 g/m² or 20 lb paper.
• Weights from 60 g/m² to 216 g/m² (16 lb to 56 lb).
• Media types:
•
Bond, standard, or recycled paper
• Card
• Pre-printed media
• Hole-punched paper
• Carbonless paper
Tray 3 must not be used to feed labels, transparencies, envelopes, or tabs. Tray 4 (Bypass Tray) can be
used for these media types.
Note: For 80 g/m², paper capacities are slightly lower than specified.
Loading Tray 3
Only A4 or 8.5 x 11 in. LEF-sized media can be loaded. The requested paper size and type must be
loaded in the tray, and the settings cannot be adjusted by the user.
Note: The printer does not warn you if the media of incorrect size is loaded.
CAUTION: A problem may occur if a tray is opened while it is being used to feed media.
1. Opening the tray automatically lowers an elevator in the base of the tray.
2. The required media is displayed on the screen. Ensure the correct media is loaded.
3. Place the media in the tray. The media must be
positioned against the left side of the tray.
•
Load pre-printed paper and labels face up
and with the top toward the front of the
printer.
• Load hole-punched paper with the holes on
the right edge.
Paper must not be loaded above the maximum fill
line.
4. Close the paper tray.
When the tray is closed, the elevator rises to feed
the media.