June 11, 2015, 715004752 Rev. A
Page 108
To install the new lamp:
1. Position the lamp so the cut-out located on the lamp base is at the 1 o’clock
position, in line with the alignment pin on the lamp housing.
Tip:
There is no additional alignment required.
Figure 4–8:
Aligning the lamp
2. Gently push the lamp forward until it bottoms into position.
3. Tighten the two captive screws.
Figure 4–9:
Lamp assembly captive screws
Cut-out on lamp
base at 1 o’clock
position
Alignment pin on
lamp housing
Captive screws
Summary of Contents for 2489
