June 11, 2015, 715004752 Rev. A
Page 31
Figure 2–2:
Location of power input on UV/Visible detector rear panel
2. Connect the male end of the power cord to a suitable wall outlet.
3. Press the power switch on the front door to power-on the detector.
Result:
The detector runs a series of startup diagnostic tests while the lamp
LED blinks green. The lamp LED shows steady green when the lamp is ignited.
2.6 Connecting signal cables
See also:
Waters Ethernet Instrument Getting Started Guide
.
The following figure shows the rear panel location of the connectors used to operate
the detector with external devices.
Figure 2–3:
Location of connectors on UV/Visible detector rear panel
Power input
Signal cable
connector inputs
and outputs
RS-232 cable
connector (for
service only)
Ethernet cable
connector
Summary of Contents for 2489
