June 11, 2015, 715004752 Rev. A
Page 109
4. Reconnect the lamp’s power connector.
Figure 4–10: Lamp assembly and power connector
5. When ready to resume operation of the detector, reconnect the power cord and
power-on the unit.
Tip:
The instrument firmware automatically delays operation for 5 minutes to
allow the lamp to warm after it has been reignited.
4.5.5 Recording the new lamp serial number
Notes:
•
Always run the Change Lamp diagnostic test after you install a new lamp (see
“Using the lamp, display, and keyboard diagnostic tests” on page 118
).
•
If you do not record the new lamp serial number following the procedure in this
section, the lamp warranty is voided.
The detector software records and stores the serial number and date of installation of
a new lamp so that you can periodically check its age and its number of ignitions.
To record the new lamp serial number:
1. When the detector warms up, press the DIAG key.
2. Press 4, Lamp, display & keypad.
3. Press 1, Change lamp.
Tip:
Be sure to enter the 9-digit lamp serial number and not the lamp part
number when performing this procedure.
4. Enter the 9-digit serial number of the new lamp in the active field.
Lamp
assembly
Power
connector
Summary of Contents for 2489
