URAL Motorcycles 4320M, Operation Manual, Page: 237 / 321

Scope of work Technical specifications
Recommended equipment,
devices and tools
Axle configu-
ration
4х4 6х6
- Torque arm stud. Loosening of the fasteners is
not allowed. If holes for cotter
pin do not match during nut
torque, tighten the nuts.
Head wrench for 50,
tire iron, pliers, screw-
driver, drive pin, hammer
+
Check and, if neces-
sary, tighten the hold-down
bolts of:
- Front mounting
bracket of front springs and
(for
trucks 4x4) rear
mounting of rear spring to
the bottom spar flange;
Loosening of the fasteners is
not allowed.
Wrenches 17х19,
22x24
+ +
- Rear mounting
bracket of front springs to
reinforcement panel of the
girder flange;
The same Wrench 22х24
(24х27), socket wrench
24, tap wrench
+ +
- Front mounting
bracket cover of rear
springs;
-«- Box wrench 22х24 +
- Balance shaft ready
fitted with balance arms
mounting brackets of the
rear suspension;
-«- Socket wrench 30х32,
tire iron
+
- Balance arms mount-
ing brackets of the rear
suspension to the cross-
arm;
-«- Wrench 17х19 +
- Mounting brackets of
upper reaction rods to axle
beams of the rear suspen-
sion;
-«- Socket wrench 24,
crank crowbar, box
wrench 22х24
+
Check the condition of
tires, wheels and their fas-
tening. See subparagraph
“Wheels and Tires”
Loosening of the fasteners is
not allowed. Wrenches 11x13,
17x19, socket wrench
27x38 for wheel nuts,
hydraulic jack handle, tire
iron with hydraulic jack
handle, truck GARO for
wheel removal.
+ +
Steering Wheel
Check tightening and,
if necessary, tighten up
retaining nuts of:
213