115
According to Figure 86:
- tighten the bolt 5 with 75-85 Nm (7.5-8.5 kgfm) torque. Lubricate “d” surface with
АМС-3 grease - GOST 2712-75
- before assembling lubricate “g” surface of axis 7 and “f” surface of brake pads with
graphite grease - GOST 3333-80. Lubricate “e”, “h” and “p” surfaces with АМС-3 grease - GOST
2712-75.
Tightening scheme for brake pad axes nuts: first tighten nut 6 with 431-490 Nm (44-50
kgfm) torque, then nut 11 with 274-313 Nm (28-32 kgfm).
If the drum is worn, if there are annular grooves deeper than 1mm, bore drum work sur-
face according to Table 13, basing on outer hub bearing rings (see Figure 94). Drum work surface
runout should not exceed 0.25 mm.
Table 13 - Brake Drum Internal Surface Diameter After Boring
Diameter after first
boring, mm
Diameter after second
boring, mm
Maximal diameter of
boring, mm
421.5
423
424.38
4.5.1.5 Speed Sensor.
Brakes of front and rear wheels have inductive sensors 2 (see Fig-
ure 95).
1-Cap; 2-inductive sensor; 3-clamping sleeve; 4-sensor target gear ring; 5-wheel hub; 6-rubber bushing
Figure 95 - Speed Sensor
A, B - base surfaces
Figure 94 - Brake Drum Adaptation Scheme
Summary of Contents for 4320M
