Tuttnauer ELARA11-D, Technicial Manual

Page: 124 / 176

Page 123
5. Reassemble the coil (2) and the nut (1).
6. Re-install the autoclave cover.
10.33
Replacing the internal PT100
Caution!
Before starting, disconnect the instrument from the power source and
ensure that there is no pressure in the autoclave.
Allow the autoclave to cool before removing outer covers.
1. Open the outer covers of the autoclave.
2. Disconnect the jacket PT100 from its connector on the control panel.
3. Unscrew the ½ nut (1) from the connector (2) and take it out
Note: Please note which length the electrode protrudes. The new electrode
must protrude into the generator to the same length.
4. Install the new PT100 in place of the old one.
Note: Make sure that the sensor protrudes for the same length as the
replaced one.
5. Perform any cycle to verify that the PT100 operates as required.
1 5 4 3 2
www.shanghaidelan.com 021-54263653