Tuttnauer ELARA11-D, Technicial Manual

Page: 81 / 176

Page 80
Note: Pulse A and B counts for standard programs equal one, with the
exception of Hollow load, Waste, and Bowie and Dick test (pre-vacuum models
only), whose pulse count equals four.
Pulse A Stay Time
This parameter defines the value of delay after the required pressure for the
pulse is reached.
1. Browse to the following folder:
Cycle parameters\Create Pulse\Pulse A Stay Time
Change the parameter as desired .
Note: Same parameters are available for other pulses. The following cycles
have four pulses pre-vacuum models only): Hollow load, Waste, and Bowie
and Dick test. Other cycles have only one pulse.
Pulse A Low Pressure
This parameter defines the lower pressure value for the A pulse.
1. Browse to the following folder:
Cycle parameters\Create Pulse\Pulse A Low Pressure
2. Change the parameter as desired .
Note: Same parameters are available for other pulses. The following cycles
have four pulses pre-vacuum models only): Hollow load, Waste, and Bowie
and Dick test. Other cycles have only one pulse.
Pulse A High Pressure
This parameter defines the higher pressure value for the A pulse
Browse to the following folder:
Cycle parameters\Create Pulse\Pulse A High Pressure
Change the parameter as desired .
Note: Same parameters are available for other pulses. The following cycles
have four pulses pre-vacuum models only): Hollow load, Waste, and Bowie
and Dick test. Other cycles have only one pulse.
9.16
Keep Heat
There are two optional stages, within the sterilization cycle, when constant
temperature (Temperature 1 or 2 stay) is maintained for certain time period
www.shanghaidelan.com 021-54263653