Tuttnauer ELARA11-D, Technicial Manual

Page: 111 / 176

Page 110
10.21
Replacing and cleaning the generator’s water level
electrode
Caution!
Before starting, disconnect the instrument from the power source and
ensure that there is no pressure in the autoclave.
Allow the autoclave to cool before removing outer covers.
1. Open the outer covers of the autoclave.
2. Open the generator insulation.
3. Unscrew the water level electrode (1).and take it out.
4. Note: Please note which length the electrode protrudes. The new
electrode must protrude into the generator to the same length.
5. Disconnect the wire.
6. Insert the new electrode and screw it tight. Make sure that the new
electrode protrudes into the generator approximately to the same length.
7. Close the generator insulation.
8. Perform any cycle to verify that water level electrode operates as
required.
2
1
1
www.shanghaidelan.com 021-54263653