Tuttnauer ELARA11-D, Technicial Manual

Page: 88 / 176

Page 87
1. Browse to the following folder:
Cycle parameters\Ending\End Temperature
2. Change the parameter as desired
9.23
Global (for some models only)
This menu defines the global cycle parameters.
F0 mode
This parameter checks how long has the load been in sterilization conditions
(pressure, temperature) before the sterilization stage actually begins. This data
helps preventing damage to the load by excessive exposure to heat and high
pressure.
1. Browse to the following folder:
Cycle parameters\Global\F0 mode
2. Change the parameter as desired
Check RTC
In this menu you can set the time interval for checking the two clocks. The two
clocks work during this interval, and the results are displayed. If the results are
different for more than 2 seconds, one of the clocks is faulty. For the procedure
of the check itself, see Maintenance\Test RTC.
1. Browse to the following folder:
Cycle parameters\Global\Check RTC
www.shanghaidelan.com 021-54263653