Tuttnauer ELARA11-D, Technicial Manual

Page: 122 / 176

Page 121
9.3. If these two conditions are fulfilled, dimension "A" is correct,
tighten screws (1).
9.4. If dimension "A" is not correct, remove the microswitch from the
panel, turn the adapter 1/2 a turn clockwise or counterclockwise
as required and reassemble it to the panel.
9.5. Repeat steps 9.1-9.4.
9.6. Reconnect the 2 wires (2, 3) to the door switch. Verify that one
wire is connected to screw no. 1 ("COM" - marked on the switch)
and the other wire is connected to screw no. 3 ("NO" marked on
the switch).
Caution!
Make sure that the door switch is installed correctly (the wheel of the
microswitch is parallel to the floor)!
Check that the operational message “Door is Open"
is displayed
when the door is opened and that the message disappears when the door
is closed.
10.31
Replacing the water pump
1. Empty the water reservoir.
2. Remove the autoclave outer cover (see 10.2).
3. Disconnect the wires from the pump (1).
4. Disconnect the piping from the pump (2).
5. Remove the pump from the rubber shock absorbers (3). If the rubber
shock absorbers are damaged, replace them.
7 8 9 11 10
www.shanghaidelan.com 021-54263653