Tuttnauer ELARA11-D, Technicial Manual

Page: 96 / 176

Page 95
Opening the door
Caution!
This option is for emergency cases only! Before opening the door,
always make sure that there is no pressure in the chamber.
1. Insert a 2 mm (0.08") pin (1) into the hole (2) located above the door
opening handle (3).
2. Press the pin downwards and, simultaneously open the door by pulling
the door handle (3) in the arrow (4) direction.
10.4
Replacing the jacket heating elements
Caution!
Before starting, be sure that the electric cord is disconnected from the
power source and that there is no pressure in the autoclave chamber.
Allow the autoclave to cool before removing outer covers.
1. Take off the autoclave covers (see 10.2).
2. Remove the insulation blanket.
3. Remove the heating element tightening bolts (2).
4. Disconnect the heating element wires from the porcelain connector.
5. Replace the heating elements (1)
6. Re-assemble the autoclave insulation and the covers.
7. Perform any cycle to verify that heating operates as required.
8. Remember to re-connect PT100 and the cut-off sensor as shown below.
1
2
4
3
www.shanghaidelan.com 021-54263653