Tuttnauer ELARA11-D, Technicial Manual

Page: 118 / 176

Page 117
10.28
Replacing the Printer
Caution!
Before starting, disconnect the instrument from the power source and ensure
that there is no pressure in the autoclave.
Allow the autoclave to cool before removing outer covers.
1. Remove the panel (see 10.24) to reveal the internal part and the
electrical connectors.
2. Unplug the board connectors (1) and the printer connectors (2). Verify
that you know where each plug is connected.
3. The printer (6) is fastened to its seat with two fasteners (5). To release
the fasteners, using a flat screwdriver, press slightly on the part marked
(4) and pull the fastener upward. Repeat this with the second fastener.
4. Pull the printer out of its seat (the hole in the panel).
5. Replace the printer with a new printer.
6. Inset the fasteners. Verify that they are inserted firmly.
7. Connect the printer's connectors
8. Connect all the connectors of the board.
9. Lay the control panel on its place.
10. Assemble the panel (see 10.24).
2
1
www.shanghaidelan.com 021-54263653