e-STUDIO2020C/2330C/2820C/2830C/3520C/3530C/4520C
© 2008 - 2011 TOSHIBA TEC CORPORATION All rights reserved
ADJUSTMENT
3 - 16
[A] Reproduction ratio of primary scanning direction (Fine adjustment of polygonal motor
rotation speed (Printer))
(1)
While pressing [0] and [5] simultaneously, turn the power ON.
→
(Adjustment Mode)
(2)
Press [98]
→
[FAX]. (A grid pattern with 10 mm squares is printed out. Use A3/LD from the 2nd
drawer.)
(3)
Measure the distance A from the 1st line to the 21st line of the grid pattern.
(4)
Check if the distance A is within 200±0.5 mm.
(5)
If not, use the following procedure to change values and measure the distance A again.
<Procedure>
(Adjustment Mode)
→
(Key in the code [401])
→
[START]
→
(Key in a value (acceptable values: 0 to 255))
→
[ENTER] or [INTERRUPT] (Stored in memory)
→
“100% A” is displayed.
→
Press [98]
→
[FAX]
→
(A grid pattern is printed out.)
*
The larger the adjustment value is, the longer the distance A becomes (approx. 0.08 mm/
step).
[B] Primary scanning data laser writing start position (Printer)
(1)
While pressing [0] and [5] simultaneously, turn the power ON.
→
(Adjustment Mode)
(2)
Press [98]
→
[FAX]. (A grid pattern with 10 mm squares is printed out. Use A3/LD from the 2nd
drawer.)
(3)
Measure the distance B from the left edge of the paper to the 6th line of the grid pattern.
(4)
Check if the distance B is within 52±0.5 mm.
(5)
If not, use the following procedure to change values and measure the distance B again.
<Procedure>
(Adjustment Mode)
→
(Key in the code [411])
→
[START]
→
(Key in a value (acceptable values: 0 to 255))
→
[ENTER] or [INTERRUPT] (Stored in memory)
→
“100% A” is displayed
→
Press [98]
→
[FAX]
→
(A grid pattern is printed out.))
*
The larger the adjustment value is, the longer the distance B becomes (approx. 0.04 mm/
step).
(6)
After the adjustment for the code 411 is completed, apply the same adjustment value for the
code 410.
(Adjustment Mode)
→
(Key in the code [410])
→
[START]
→
(Key in the same value in the step 5 above)
→
Press [ENTER] or [INTERRUPT] (Stored in memory).
Note:
Make sure the first line of the grid pattern is printed out since the line is occasionally vanished.
