e-STUDIO2020C/2330C/2820C/2830C/3520C/3530C/4520C
© 2008 - 2011 TOSHIBA TEC CORPORATION All rights reserved
ADJUSTMENT
3 - 18
[D] Secondary scanning data laser writing start position
Performing the code 05-408 covers this adjustment for all paper sources.
The adjustment for each paper source is also available.
For all paper sources
For each paper source
(1)
While pressing [0] and [5] simultaneously, turn the power ON.
→
(Adjustment Mode)
(2)
Press [98] ([3] for duplexing)
→
[FAX]. (A grid pattern with 10 mm squares is printed out.)
(3)
Measure the distance D from the leading edge of the paper to the 6th line of the grid pattern.
*
Normally, the 1st line of the grid pattern is not printed.
*
At the duplexing, measure it on the top side of the grid pattern.
(4)
Check if the distance D is within 52±0.5 mm.
(5)
If not, use the following procedure to change values and measure the distance D again.
<Procedure>
(Adjustment Mode)
→
(Key in the code shown above)
→
[START]
→
(Key in an acceptable value shown above)
→
[ENTER] or [INTERRUPT] (Stored in memory)
→
“100% A” is displayed
→
Press [98] ([3] for duplexing)
→
[FAX]
→
(A grid pattern is printed out.)
*
The larger the adjustment value is, the longer the distance D becomes (approx. 0.10 mm/
step).
Code
Paper size
Acceptable value
Remarks
408
A3/LD
0 to 200
Performs the adjustment for all paper sources.
Order for
adjustment
Paper source
Code
Paper size
Acceptable
value
Remarks
1
1st drawer
440
A4/LT
0 to 100
2
2nd drawer
441
A3/LD
0 to 100
3
3rd drawer
444
A4/LT
0 to 100
4
4th drawer
428
A4/LT
0 to 100
5
Bypass feed
442
A4/LT
0 to 100
6
Duplexing
445
A3/LD
0 to 100
Paper fed from the 2nd drawer
