Assembling the Roller (continued)
IMPORTANT
Failure to grease bearing lock nut before seal installation may result
in seal damage.
5. Fill the seal 75 to 90% full with #2 grease and apply a coating of grease to
the underside of the bearing lock nut to prevent damaging the seal damage
during installation. Carefully fit a seal onto each bearing lock nut.
g206892
Figure 168
1.
Seal
2.
Bearing lock nut
6. Install a bearing lock nut with seal onto each end of the roller shaft. Tighten
the bearing lock nuts until they bottom against the bearings. Remove the
bearing lock nuts and clean away any grease.
g206893
Figure 169
1.
Seal
2.
Bearing lock nut
7. Position an assembly spacer and yellow assembly washer on each end of
the roller shaft.
DPA Cutting Units: Service and Repairs
Page 7–28
Greensmaster® eTriFlex 3360 and 3370
19239SL Rev B
